HydroSense Application Data Sheet

Please fill in as much information as possible. Some information is required to determine the suitability of the instrument. Other information will help us understand your application better. We may be able to provide some further installation and monitoring guidance.

  1. Agent/Representative_____________________________
  2. Prepared by_____________________date____________
  3. End User Information

    4. Name: ________________________

    Address: ________________________

    Site: ________________________ Contact__________________

    Tel:_____________________

  4. Application Description (brief overview of process and reason for monitoring the water for hydrocarbons)

    5. ________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

     

  5. Water Source Description

    6. __ sump pit __process tank __process pipe __vessel __ditch __open channel __separator __well __offshore platform __cooling water pipe

    __other________________________________________________________________

  6. Water Type

    7. __storm water __waste water __treated water __process water __cooling water

    __condensate __drinking water __sewer __ground water __sea water __distilled water

    __other________________________________________________________________

     

     

     

  7. Compound to be monitored (describe the contaminant, chemical name, structure, source etc.)

    8.  

    minimum ppm to be measured______, maximum ppm to be measured____

  8. Are there other contaminents or products in the water ?_______

    9. Describe____________________________________________________________

    Do they vary in their concentrations ? _______

  9. Is there any colour in the water?_______Describe___________________________
  10. Are there any suspended solids (turbidity) in the water ?_______

    11. What range?_________________

    Describe________________________________________________________

    Process Information

  11. Is there a continuous sample flow available to the HydroSense? _______
  12. What is the flow range ?_______________
  13. What is the pressure in the process ?______
  14. What is the pressure in the stream line to the HydroSense?______
  15. Can the sample stream outfall from the HydroSense go to an open drain or containment? _____
  16. Is the sample stream pumped from the process source to the HydroSense? ______

    17. If yes, what type of pump ? _____________________________

  17. What is the process stream temperature range___________
  18. What is the HydroSense enclosure location temperature range_________
  19. Area Classification of HydroSense installation: General Purpose Type 12___

    20. Type 4___

    Hazardous Zone 0___

    Zone 1___

    Zone 2___

  20. What is the input power available? __24 vdc __110 vac __220 vac
  21. Are the relays being used? Describe_________________________________________
  22. Is the 4-20 mA output being used? Describe____________________________________

    23. 21. Do you presently have grab samples tested? __laboratory on site __send to outside lab. What technique and compounds are measured ? ____________________________________________________________________

  23. Does the process ppm concentration vary on a regular basis ?_________
  24. Do you have the ability to force a change or make up a ppm in water sample for calibration purposes ? _______________________________________
  25. Is the monitoring intent to determine an upset condition or to record and evaluate actual ppm levels?

Describe___________________________________________________________